來聊一聊自上料攪拌車氣缸破裂的預防？
自上料攪拌車氣缸的作用是將壓縮空氣的壓力能轉換為機械能，驅動機構作直線往復運動、擺動和旋轉運動。在使用中有出現氣缸破裂現象，導致無法實現其性能，故，我們應做好其防治措施。
The function of the cylinder of the self feeding mixer is to convert the pressure energy of the compressed air into mechanical energy, and the driving mechanism makes linear reciprocating motion, swing and rotary motion. In use, there is a cylinder rupture phenomenon, leading to its performance can not be achieved, so we should do its prevention and control measures.
自上料攪拌車如果氣缸套出現破損，發動機在進氣行程時會吸入冷卻液，而在壓縮行程和做功行程時高壓氣體又會從破損處進入冷卻水道。無論出現哪一種情況，都將妨礙可燃混合氣的形成和燃燒，甚使發動機無法正常工作，將嚴重影響發動機的使用壽命。
If the cylinder liner of self feeding mixer is damaged, the engine will inhale coolant during the intake stroke, and the high-pressure gas will enter the cooling channel from the damaged part during the compression stroke and power stroke. No matter what happens, it will hinder the formation and combustion of combustible mixture, and even make the engine unable to work normally, which will seriously affect the service life of the engine.
導致氣缸破裂的因素很多，要防止氣缸破裂，應該做到：發動機溫度過高時，必須等發動機溫度降低后，再加水發動;不得先起動發動機，后加冷卻水，以免使氣缸崩裂;在嚴寒條件下車，須放凈冷卻水，起動車時建議加熱水起動;冬季停車若時間較長，又不能放水時，可間歇發動車輛，保持發動機有一定溫度而不致于結冰，不得用噴燈或明火直接烤車，同時使用的冷卻水要潔凈。
There are many factors leading to cylinder rupture, to prevent cylinder rupture, we should do: when the engine temperature is too high, we must wait for the engine temperature to reduce, and then add water to start; Do not start the engine first, and then add cooling water, so as not to crack the cylinder; When getting off the train in severe cold conditions, it is necessary to drain the cooling water. When starting the train, it is recommended to start with heating water; In winter, if the parking time is long and the water can not be discharged, the vehicle can be started intermittently to keep the engine at a certain temperature without freezing. It is not allowed to use blowtorch or open fire to bake the car directly. At the same time, the cooling water used should be clean.
自上料攪拌車氣缸破裂防治措施就為大家介紹到這里了，更多詳情資訊請繼續關注我們網站。
Since the feeding mixer cylinder rupture prevention measures are introduced here, more details please continue to pay attention to our website.
