As we all know, the working environment of the concrete mixer is relatively bad, and as an engineering vehicle, the body of the mixer is heavy, if you need to reverse, you need to master the relevant driving skills to ensure safety, but for many novice drivers, it is still very difficult to make the concrete mixer pour out smoothly, so this paper puts forward some suggestions For you to sort out the following tips, please read together.

◆非”字形倒車

Non reversing

所謂的“非”字形倒車就是兩輛并排停著，中間有一個停車位，這樣的倒車方法是：先將混凝土攪拌車開到距離車位線旁邊約1.5米的位置，讓自己攪拌車的駕駛位置處于隔車中間位置時，向左打滿舵，然后向后倒車。當你確認自己的車頭擺正時，馬上回正車輪向后倒車，這樣車就可以準確地停到車位上。反方向倒車也是如此，只需要將方向盤打滿舵的方向調整一下就可以了。為了確認這種停車方法的有效性，實驗了一下，按照上述方法進行操作，結果真的很管用，攪拌車很順利地停進了停車位。倒車時車速要慢，要通過后視鏡觀察自己的混凝土攪拌車與旁邊兩車的距離，切勿心急。

The so-called "non" shape reversing means that two cars are parked side by side with a parking space in the middle. This reversing method is: first drive the concrete mixer to a position about 1.5 meters away from the parking line, and when the driving position of the mixer is in the middle of the car, turn the rudder to the left, and then reverse. When you make sure that your car is in the right position, you should return to the right wheel and back up, so that the car can stop in the parking space accurately. Reverse direction reversing is the same. Just adjust the steering wheel with full rudder. In order to confirm the effectiveness of this parking method, the experiment is carried out, and the operation is carried out according to the above method. The result is really effective, and the mixer is successfully parked in the parking space. When reversing, the speed should be slow. You should observe the distance between your concrete mixer truck and the two cars nearby through the rear-view mirror. Don't be impatient.
            

◆“一”字形倒車

"One" reversing

“一”字形倒車其實就是側方停車，車輛像一個“一”字一樣依次排開，這樣停車一般都是停在馬路邊。這種倒車的方法是：先將自己的混凝土攪拌車停到前車左側約50厘米的地方，自己車與前車保持平行。當自己車的右后視鏡與旁邊車輛B柱對準的時候，向右打滿舵，然后倒車；當自己的攪拌車與前車成45度夾角時（即你自己的車頭和前車車尾的連線是一條直線的時候），向左打滿舵，繼續(xù)倒車。當車進入車位時，回輪擺正車身即可。這樣倒車需要注意的是當你向左打滿舵往車位里倒車時，要時刻觀察后視鏡，掌握好自己混凝土攪拌車與后車和馬路牙子之間的距離，保障。倒車時切記速度要慢，要前后左右都照顧到。

"One" shape reversing is actually side parking, vehicles are arranged in turn like a "one", so parking is generally stopped at the side of the road. This reversing method is: first, park your concrete mixer truck to the left side of the front truck about 50 cm, and keep your truck parallel to the front truck. When the right rear-view mirror of your car is aligned with the B-pillar of the vehicle beside you, turn full rudder to the right, and then reverse; when your mixer is at an angle of 45 degrees with the vehicle in front (that is, when the line between your front and the rear of the vehicle in front is a straight line), turn full rudder to the left, and continue to reverse. When the car enters the parking space, the return wheel can straighten the car body. When reversing like this, you need to pay attention to the fact that when you turn the rudder to the left to reverse into the parking space, you should always observe the rear-view mirror, and master the distance between your concrete mixer and the rear car and the curb, so as to ensure safety. When reversing, remember to be slow and take care of the front, back, left and right.

◆斜線停車

Diagonal parking

斜線停車相對于“非”字停車和“一”字停車要簡單些，這種停車方法是：將車開到左后視鏡與車位左線對齊的位置，然后向右打滿舵前行。當車身與車位成一條直線時開始回輪向后倒車，這樣混凝土攪拌車就可以輕松進入車位。

Diagonal parking is simpler than "not" parking and "one" parking. This parking method is: drive the car to the position where the left rear-view mirror is aligned with the left line of the parking space, and then turn the rudder to the right. When the car body is in a straight line with the parking space, start to reverse the wheel, so that the concrete mixer can easily enter the parking space.